What matters to us: structural engineering and safety by German rules
An LED wall can easily weigh several hundred kilos – often above people’s heads. Why structural calculations, inspections and German rules are not red tape, but responsibility.
A large LED wall is not a television. It hangs from truss, stands on ground supports, and outdoors the wind acts on it. Anyone who flies or stacks a wall needs to know what loads occur, where the rigging points are and what happens if something gives way. That applies to the big touring wall just as much as to the wall on an exhibition stand.
In Germany there are clear rules for this: the DGUV accident prevention regulations for events and productions, the Versammlungsstättenverordnung (places of assembly regulation), the VDE regulations for the electrics and, for outdoor use, the wind load standards. On top of that come inspection logbooks, acceptance inspections and documents that have to be shown on site.
Many LED walls today come straight from the Far East – inexpensive, but often without structural certificates, without German documentation and without anyone to contact when it really matters. This comes to light at the latest when an expert carries out the acceptance inspection. In the worst case, only when something happens. And then it is not the dealer on the other side of the world who is liable, but whoever set up the wall.
This matters to us. That is why, at LEDTEK, we rely on TÜV-tested products and structurally calculated set-up variants that are permitted in the DACH region. Anyone who sets up one of our walls has the documents they need for it in their hands.
And that is why the topic belongs at LEDdays: as a talk in the lounge, in conversations at the stands and with experts who know their way around structural engineering and acceptance inspections. So that in the end everyone gets home safely – audience, crew and organisers.